How To Repair The G903 Mouse

Before you begin, flip the mouse's power switch into the red OFF position.

Before you brainstorm, flip the mouse's power switch into the reddish OFF position.

If you're planning to reuse your existing mouse feet, note that the adhesive needs to be thoroughly heated to cleanly remove them.

If you're planning to reuse your existing mouse anxiety, annotation that the adhesive needs to be thoroughly heated to cleanly remove them.
Heat an iOpener and employ it to the lesser mouse foot for two minutes.
A pilus dryer or heat gun may also be used, but be careful not to overheat the mouse—the internal battery is susceptible to rut damage.

Slide an opening pick under an edge of the bottom mouse human foot.
Become slowly, and make sure the selection is underneath both the foot and its adhesive layer if you want to reuse the human foot. It'due south easy to separate the pes from its adhesive.
If the foot feels stuck, apply more heat before continuing.
Slide the selection under the rest of the human foot until you lot can elevator it off the mouse.
Remove the foot.

If the adhesive separated from the foot:
Slide the flat cease of a spudger nether an border of the agglutinative. If the adhesive seems stuck, you may need to heat the adhesive further.
Peel the agglutinative off.
Earlier installing new feet or reinstalling sometime ones, wipe abroad any agglutinative residue from the mouse with a lint-costless cloth and high-concentration isopropyl alcohol.

Repeat the previous mouse feet removal procedure and remove the two pentagonal mouse feet on the left and right side.

The Logitech sticker at the bottom of the mouse is very heat sensitive and crumbles easily. In case you want to continue that sticker intact apply as fiddling heat as possible and remove the sticker carefully.
If you don't want to remove the sticker all the mode, yous can puncture it with a screwdriver where the ii screws are located beneath it. Use this film to brand sure you lot're hitting the correct spots.
Estrus an iOpener and apply information technology to the Logitech sticker to loosen its adhesive.

Slide an opening pick nether an edge of the Logitech sticker.
In case you want to reuse the sticker become slowly, and avoid violent or crumbling the sticker.
If the sticker feels stuck, apply a lilliputian flake more heat earlier continuing.
Slide the pick under the residuum of the sticker until you lot tin peel it off the mouse.
Remove the sticker.

Utilise a Phillips screwdriver to remove the seven 4.5 mm screws securing the two halves of the mouse together.

Don't completely separate the 2 halves all the same—they're even so tethered together by a delicate cablevision.
For meliorate access, open the top one-half of the mouse in the direction of the rear finish.

Employ a spudger, an opening tool, or your fingernail to flip up the pocket-size, hinged locking flap on the interconnect cable ZIF connector.

Apply a pair of blunt nose tweezers or your fingers to slide the interconnect cablevision out of its socket.

Use a pair of blunt tweezers to grasp the sides of the battery connector.
Pull the connector up and out of its socket, gently rocking information technology back and forth to loosen the clips securing it.