How To Remove Carpet Nails

If you don't like tack stripes left on the edges of your room, then you must know how to remove carpet tack strips. The strips of metallic tacks under your rug and rug padding are referred to as tack strips.

Discarding old rugs may be essential to save labor expenses if you are having your carpeting replaced. You may also want to remove your mat if yous have hardwood floorings under your carpeting that you would like to utilize a new blanket on.

If you desire to install a new carpet, you do non have to discard the tack strips; you lot tin can use them once again to concur the new carpet. If you want to refinish the hardwood floors underneath your carpet or intend to tile the surface, you accept to remove the tack strips.

After removing your rug, y'all will most probably take tack strips left around the edge of the room. Extracting these tack strips that once gripped your carpet is the most tiresome aspect of rug removal.

To remove carpeting tack strips, slip a wide putty knife between the tack strip and the floor beside the blast caput, then put in a pry bar nether the putty knife. Slam the other end of the pry bar softly with a hammer every bit this pulls out the blast from the floor.

How to Remove Carpet Tack Strips

Items Needed

Work gloves
Utility knife
Hammer
Boots
Painter'due south tool
Pry bar
Carpet staple remover
Gloves (optional)
Broom or vacuum
Trash bag
Sturdy clothes

Procedure

Put on heart protection, thick work clothes, gloves, and boots before you start removing tack strips. Find a nail head on top of the tack strip.

If the old carpet was installed over a hardwood floor that you now want to renew, sideslip a broad putty pocketknife betwixt the tack strip and the floor beside the smash caput, then put in a pry bar under the putty pocketknife.

Suppose a floor is under the sometime rug that you intend to cover once more with a new carpet set in the pry bar directly under the tack strip.

You tin can use the utility knife to cutting the carpet into like shooting fish in a barrel strips, which you volition later roll up and remove. Rug textures are pretty hard, so you will possibly have to make 2 or three passes to cut all the way through.

There is no necessity for a cautious touch unless there is a good hardwood floor underneath that you attempt to rescue information technology from being damaged.

Slam the other stop of the pry bar softly with a hammer. This should bring the boom out of the floor. If the floor is accurate, you might have to striking the pry bar with more pressure.

Many pry confined are too hard on their prying end to effortlessly ready in between the tack strip and the floor. Using the painter's tool, you can create a space, and the pry bar will fit correct in.

Remove the pry bar and pull out the putty knife if yous are using it. Put them in again beside the post-obit nail on the tack strip, and popular that smash out a similar way. Start similar this once more until you take loosened the entire strip.

You accept to be careful when removing carpet tack strips; those tacks are very abrupt.

Related: How to get wrinkles out of rug without a carpet stretcher

Dispose of the old tack strip in a large trash bag. Repeat the method with the other tack strips in the room. Observe the floor for devious tacks that did not pull free with the tack strips. Pull them out with the hook edge of the hammer and discard them.

Vacuum or sweep the floor to discard whatever grit. Discarding tack strips can leave sharp $.25 of metal or wood backside; you tin can pull them and ensure that the floor is neat.

Read: All-time Vacuum Cleaner Review

Determination

On knowing how to remove carpet tack strips, you shouldn't have any worries when changing your carpet. Keep in mind that these strips are very abrupt, ensure to have your boots on to avoid accidents.