How To Remove Bottom Drawer From Whirlpool Oven

14

Storage Drawer

(on some models)

The storage drawer tin can be removed. Before removing, make certain

drawer is cool and empty.

To Remove:

one.

Pull the storage drawer straight back to the drawer stop.

ii.

Lift upwards the forepart of the drawer and pull the drawer out.

To Replace:

1.

Lift upward the front end of the drawer and place the rear of the drawer

inside the range then that the drawer terminate notch is behind the

drawer glide.

ii.

Lower the drawer and then that the border of the slide rails drops into

the slot in the drawer glide.

3.

Slowly push the drawer into the range.

Annotation:

When properly installed, the rear slides on the bottom

of the drawer volition engage the base rails and the drawer will

non tip when items are placed in the drawer.

Oven Door

For normal range use, information technology is not suggested to remove the oven

door. However, if removal is necessary, brand sure the oven is off

and cool. Then, follow these instructions. The oven door is heavy.

To Remove:

i.

Open up oven door all the way.

2.

Pinch the swivel latch between two fingers and pull forward.

Repeat on other side of oven door.

3.

Close the oven door every bit far as it will shut.

4.

Lift the oven door while holding both sides.

Proceed to push the oven door airtight and pull it abroad from

the oven door frame.

To Replace:

1.

Insert both hanger artillery into the door.

2.

Open the oven door.

You should hear a "click" as the door is fix into identify.

iii.

Move the hinge levers back to the locked position. Bank check

that the door is free to open and shut. If it is non, repeat the

removal and installation procedures.

Consummate Installation

one.

Check that all parts are at present installed. If in that location is an extra role,

go back through the steps to see which step was skipped.

2.

Check that you take all of your tools.

3.

Dispose of/recycle all packaging materials.

4.

Check that the range is level. Meet the "Level Range" section.

five.

Utilise a mild solution of liquid household cleaner and warm

water to remove waxy residual caused by aircraft material.

Dry thoroughly with a soft material. For more than information, read

the "Range Care" section of the Employ and Intendance Guide or User

Instructions or User Instructions.

6.

Read the "Range Utilize" section in the range Use and Care

Guide or User Instructions.

7.

Plug power string into advisable outlet. Turn power on.

viii.

Plow on surface burners and oven. See the Use and Care

Guide or User Instructions for specific instruction on range

operation.

If range does not operate, bank check the following:

■

Household fuse is intact and tight; or circuit breaker has not

tripped.

■

Range is plugged into a grounded outlet.

■

Electrical supply is connected.

IMPORTANT:

If the range command displays an "F9" or "F9, E0"

error code, the electrical outlet in the home may exist miswired.

Contact a qualified electrician to verify the electrical supply.

■

See the "Troubleshooting" department in the Utilize and Care Guide

or User Instructions.

When the range has been on for five minutes, check for heat. If

range is cold, turn off the range and contact a qualified

technician.

A. Drawer stop notch

A. Engage drawer glide.

A. Swivel latch

A

A

A

Source: https://www.manualowl.com/m/Whirlpool/WFE540H0ES/Manual/448612?page=14

Share this post